Used for adding Beads and Hangs, or connecting to Findings
How To Make A Loop
1.Choose the right length of the Pin and cut it leaving about 8mm if it is too long.
1.Choose the right length of the Pin and cut it leaving about 8mm if it is too long.
2.Bend the center of the Pin at an angle of 90 degrees.
3.Hold the Pin with the plier. **Using a piece of cloth or tissue paper will protect the pin from getting scratched.
4.Rotate your wrist gradually and loop the Pin.
5.Make same loop at the top and bottom of the Pin
How To Connect Each Pin
1.Twist the loop to the front and back and open it.
1.Twist the loop to the front and back and open it.
2.Attach to the finding.
3.Close the Loop